”;
This article gives a detailed account of plumbing basics. It helps the
homeowner fix a dripping faucet or pipe.
One of the basic plumbing projects that often face homeowners is a
dripping faucet or tap. This project is probably one of the easier
repairs that a homeowner can do by himself. Not only is the repair easy
but it is usually necessary to know how to do it because this is one of
the recurrent problems that plague homeowners. It is important to keep
taps and faucets in good working condition because they are the
dispensers of water in and out of the home. Dripping faucets will
eventually lead to a full blown spray of water if left unattended and
can cause some serious water damage in the home. It is not advisable to
try to force the faucet tighter if it shows some signs of a leak because
the force can damage the faucet itself and make it more difficult to
repair.
Tools and Materials
The homeowner who is venturing into plumbing will need a pipe wrench
that is congruent in size to the pipes found in the house. Other tools
and materials that may be needed is a screwdriver, replacement washers
and some PTFE tape.
How to Do It
The first thing to do is to turn off the water shut off valve for this
section of the house or the entire water main (if there are no shut off
valves) to prevent water damage if the faucet or tap bursts as the
homeowner is unscrewing the faucet or disassembling the tap. There are
four basic types of faucets and each has a different mechanism for
releasing and stopping the water. Compression faucets are the most
likely to leak just after a few years of use because the washers are
pressed down against the metal to open and close the tap. A plumbing kit
may be useful for this kind of faucet. Some compression faucets drip
from the handle and a different kind of repair is needed for this. If
the drip is from the spout, it is necessary to disassemble the entire
faucet and replace the washers. The handle of the compression faucet
will come off easily just by removing the cap from the top and
unscrewing the screw found there. There should be a retaining nut on the
threaded spindle which will be followed by an o0ring and then the
washer. Either the o-ring or the washer may need to be replaced if these
show signs of wear. It also helps to put some PTFE tape around the
threads of the spindle to ensure a tighter fit. One round of PTFE tape
should do the trick for a not so worn out thread. Reassemble the faucet
and then turn on the water valve to check if the leak is still there.
Article Tags:
Compression Faucet, Ptfe Tape
Source: Free Articles from ArticlesFactory.com
ABOUT THE AUTHOR
Dallas plumbing will help you keep your water running and your family happy. To find a qualified one please see the following: http://www.angieslist.com/